How To Install The Mh Processor; How To Prepare The Electrical Connections On Sh Model; Figure 10: Mh Processor, Side View - Toro MH-400 Operator's Manual

How to Install the MH Processor

The MH Processor is used to screen a wide variety of
material.

Figure 10: MH Processor, side view

A. Option control valve reference
B. Hose connections
C. Quick-attach brackets
D. MH Processor
E. Hydraulic hoses
1. Using the hydraulic controls, raise the MH-400 so
the quick attach brackets are aligned with the top of
the hopper of the processor.
: Use your option caddy to lift
C
AUTION
the stand (see How to Operate the
Option Caddy on page 33) or use a
crane or forklift to lift at the provided
lifting point.
2. Install the processor into the quick-attach brackets at
the rear of the MH-400 (see How to Mount the
Options on page 17).
Note – Ensure that the option extends to the right of the
MH-400 when being viewed from the rear.
3. Connect the hydraulic hoses to the option control
valve on the rear MH-400 fender (see How to
Connect the Option's Hydraulics on page 18).
Ensure that the hydraulic hoses run horizontally.
4. With the tow vehicle hydraulics operating ensure that
the option is operating properly. (see Operating
Instruction on page 22)
Page 20
How to Prepare the Electrical
Connections on SH Model
There are three available electrical connections to be
made with your MH-400 SH model:
•
Electrical power from your tow-vehicle
•
On/Off Pendant
•
Electric Brakes (if equipped)
1. Install the Tow-Vehicle electrical connection kit to
the tow-vehicle's battery, being careful to route the
wires safely to avoid heat or abrasion damage.
Connect the MH-400 SH electrical harness into the
tow-vehicle's plug.
2. Install the pendant assembly plug into the
appropriate plug in the front of the MH-400 SH.
3. Position the left (floor) control valve in the unload or
load position. Start the tow vehicle and engage the
hydraulics from the tow vehicle.
4. Test the on/off pendant switch by turning it on and
off. You should audibly hear the solenoid open and
close.
Note – Removing the power to the solenoid will force the
MH-400 SH to use hydraulic power from the tow vehicle.
When not using the MH-400 SH, always disconnect the
power wire for the solenoid at the battery or at the quick
connections at the hydraulic hoses. If the power is not
disconnected, the solenoids on the MH-400 SH will drain
the battery of the tow vehicle.
Setup Instructions