How To Operate The Swivel Kit; How To Operate The Mh Processor; How To Adjust The Teeth Or Remove Jammed Material; How To Run Material Through The Mh Processor - Toro MH-400 Operator's Manual

How to Operate the Swivel Kit

To direct the flow of material from the cross conveyor in
any direction, pull up the spring-loaded locking pin on
the swivel kit into the unlock or open position. This
allows you to manually move the cross conveyor freely
from side to side on the swivel bearing (Figure 22).
To keep the cross conveyor in a fixed position, release
the spring-loaded locking pin into one of the five locking
positions on the swivel kit.
Note – When traveling over uneven terrain, raise the
MH-400 to the maximum safe traveling range. This
provides more ground clearance for the cross conveyor.
See safety decals on page 12 for safe traveling range.
Figure 22: Cross conveyor positions with swivel kit
A. Extended position when conveying
B. Centered position when traveling
C. Cross conveyor
D. Swivel kit
E. Swivel lock pin
F. Remove or flip up the deflector

How to Operate the MH Processor

How to Adjust the Teeth or Remove Jammed
Material
1. Ensure machine is turned off and the hydraulics are
disconnected.
: Never reach under the guards
D
ANGER
or make adjustments while the conveyor
belt is running or the hydraulics are
connected.
2. Pull tension clamp down to release tension on
springs.
3. Remove guard(s) to access teeth.
Operating Instructions
4. Adjust teeth to the desired height. Make sure the
ridges on the conveyor belt will not contact the teeth.
You may have to experiment with teeth height to
obtain desired results for the material you are
processing.
5. Replace guards and pull the tension clamp up to
engage the teeth.

How to Run Material through the MH Processor

1. Turn on the tow vehicle hydraulics.
2. Open the adjustable section of the rear gate on the
MH-400 to allow for the desired flow rate.
3. On SH models using the control levers, turn on the
option and the conveyor belt (unload position).
4. On EH models operate the option and the conveyer
belt with the control pendant
5. To stop material moving, turn off the on/off pendant
switch or belt control lever.
Note – For SH models the on/off pendant switch stops the
MH-400 conveyor belt, not the processor conveyor belt.
6. When processing is complete, release unwanted
material from bottom of conveyor by pushing down
on the gate release handle.
: The hydraulic motor can
C
AUTION
become extremely hot. Contact your
distributor if using a high duty cycle.
Figure 23: MH Processor, rear view
A: MH Processor
B: Tension clamp
C: Guards
D: Gate release handle
Page 33