Unit Configuration - Aceinna IMU383 Series User Manual

IMU383ZA Series User's Manual
________________________________________________________________________

Unit Configuration

The Unit Configuration window (See Figure 18) gives the user the ability to view and alter the
system settings. This window is accessed through the "Unit Configuration" menu item under the
configuration menu. Under the "General" tab, users have the ability to verify the current
configuration by selecting the "Get All Values" button. This button simply provides users with
the currently set configuration of the unit and displays the values in the left column of boxes.
There are three tabs within the "Unit Configuration" menu; General, Advanced and BIT
Configuration. The General tab displays some of the most commonly used settings. The
Advanced and BIT Configuration menus provide users with more detailed setting information
that they can tailor to meet their specific needs.
To alter a setting, simply select the check box on the left of the value that you wish to modify and
then select the value using the drop down menu on the right side. Once you have selected the
appropriate value, these settings can be set temporarily or permanently (a software reset or power
cycle is required for the changes to take affect) by selecting from the choices at the bottom of the
dialog box. Once the settings have been altered a "Success" box will appear at the bottom of the
page.
 IMPORTANT
Caution must be taken to ensure that the settings selected are compatible with the system that is
being configured. In most cases a "FAIL" message will appear if incompatible selections are
made by the user, however it is the users responsibility to ensure proper configuration of the unit.
 IMPORTANT
Unit orientation selections must conform to the right hand coordinate system as noted in Section
3.1 of this user manual. Selecting orientations that do not conform to these criteria are not
allowed.
Doc# 7430-1398-01 Page 63
Downloaded From Oneyac.com