Pc Connection Settings - GRAPHTEC GL400 User Manual

4.7 PC Connection Settings

The GL400/350 can be connected to a computer via USB or TCP-IP (LAN).
(1) Click the "Connect" button on the main menu to display the Connect window.
Select USB or TCP-IP.
(2) Edit
Several settings need to be made to enable connection to your PC.
No.:
Name:
IP Address:
Port:
USB ID:
Group:
When all the settings have been made, click the "OK" button to complete the setting operation.
(3) Connect, Disconnect/Load Conditions, Save Conditions
Connect:
Disconnect:
Load Conditions: Click this button to load previously-saved settings and enable changes to be
Save Conditions:Click this button to save the settings. Please specify the file name and save
Select a number from 1 to 10. When a number is selected, a submenu
(settings list) appears.
Enter a name for device control (any name).
Set the IP address for the GL400/350 connected (when using network).
Set the port number for the GL400/350 connected (when using network)
Set the ID number for the GL400/350 connected (when using the USB
interface)
When two or more GL400/350 devices are being used for simultaneous
measurement, register them in the same group. This setting must be made
for simultaneous measurement.
Click the "Connect" button to connect the GL400/350 to the computer when
all the settings have been made.
Click this button to cancel the Connect status. If the GL400/350 is not
connected and this button is clicked, the "Device not connected" message
will appear on the screen.
made if required.
destination. The file name will have a .cfg extension.
Software
4-13