Table of Contents
Advertisement
Software
4.8 Measurement Parameters Settings
Click the "Settings" button on the main menu to enable device and measurement parameters for the GL400/
350 to be made.
CHECKPOINT
The GL400/350 settings are changed whenever the "OK" or "Apply" button is clicked in each setting menu.
AMP Settings
(1) Select CH
Specify a group or groups of channels in the range [1 to 10] through [91 to 100].
Analog AMP Settings:
• Line Color: Specifies the color for each channel.
• Annotation: Up to 11 characters can be input for each channel.
• Input: OFF, DC, Temp
• Range
Temp: Specify one of the following:
• Filter: Off, On
• Unit: The measurement unit is displayed during measurement.
All CH: Sets the Input, Range, and Filter values to the same values for all the channels in the
4-14
CAUTION
Certain characters used here may not be displayable on the GL400 monitor.
Sets the input type for each channel.
DC: 20, 50, 100, 200, 500 mV, 1, 2, 5, 10, 20, 50 V
CHECKPOINT
For the 1-5V range, select 5V, and then specify 5V for the upper span limit and 1V for the lower
span limit.
TC-K, TC-J, TC-T, TC-E, TC-B, TC-R, TC-S, TC-N, TC-W, Pt100, JPt100.
Select On if you need to cut noise.
displayed group. Click the "Set" button next to "All CH" to make the settings.
Advertisement
Table of Contents
