Table of Contents
Advertisement
Software
Other
The GL400/350 device settings and email settings when an alarm has been generated are made
here.
(1) Device Number
Specifies the Device Control Number for settings.
(2) Synchronize PC and Device clocks
Click this button to change the GL400/350's clock setting to match that of the computer.
(3) Room Temp. Compensation: Off, On
This function is only used when a temperature range has been specified. "On" is normally
selected. When making this setting, there is a choice between Internal (the GL400's room
temperature compensation settings are used) or External. Select External when you have the
necessary equipment and know-how.
(4) External Filter: Off, On
It sets whether or not to use an external filter.
(5) Burn out: Off, On
This function is only used when a temperature range has been specified. It is normally set to
"On". When a thermocouple sensor has burnt out, that status is displayed on the screen.
(6) Power On Start: Off, On
This function enables the settings that were in effect when measurement last ended to be used
to start measurement as soon as the power is switched on. (Data being measured using the
OPS022 software cannot be captured when the Power On Start function is used).
(7) Factory Default
This parameter returns all the settings to the factory defaults. Use this function when you want
to start from scratch.
(8) Send E-mail
Send E-mail when an alarm is generated: Check this box to enable this function.
Mail Address: Email can be sent to five locations.
Comments:
4-24
Please set the addresses in accordance with your computer system.
Comments can be recorded for each email setting to explain the contents.
(Email is actually sent when an alarm is generated.)
Advertisement
Table of Contents
