Table of Contents
Advertisement
SECTION 8: WIRING
These pages are current at the time of printing. However, in the spirit of improvement, we
may make changes to the electrical systems of future tools. Compare the manufacture date
of your tool to the one stated in this manual, and study this section carefully.
If there are differences between your tool and what is shown in this section, call Technical
Support at (570) 546-9663 for assistance BEFORE making any changes to the wiring on
your tool. An updated wiring diagram may be available. Note: Please gather the serial
number and manufacture date of your tool before calling. This information can be found on
the main tool label.
SHOCK HAZARD. Working on wiring
that is connected to a power source is
extremely dangerous. Touching electrified
parts will result in personal injury including
but not limited to severe burns, electro-
cution, or death. Disconnect the power
from the tool before servicing electrical
components!
MODIFICATIONS. Modifying the wiring
beyond what is shown in the diagram
may lead to unpredictable results, includ-
ing serious injury or fire. This includes
the installation of unapproved aftermarket
parts.
WIRE CONNECTIONS. All connections
must be tight to prevent wires from loos-
ening during tool operation. Double-check
all wires disconnected or connected dur-
ing any wiring task to ensure tight con-
nections.
CIRCUIT REQUIREMENTS. You MUST
follow the requirements at the beginning
of this manual when connecting your tool
to a power source.
The photos and diagrams
included in this section are
best viewed in color. You
can view these pages in
color at www.grizzly.com.
-20
-
Wiring Safety Instructions
WIRE / COMPONENT
Damaged wires or components increase
the risk of serious personal injury, fire, or
tool damage. If you notice that any wires
or components are damaged while per-
forming a wiring task, replace those wires
or components.
MOTOR WIRING. The motor wiring
shown in these diagrams is current at
the time of printing but may not match
your tool. If you find this to be the case,
use the wiring diagram inside the motor
junction box.
CAPACITORS / INVERTERS.
capacitors
and power inverters store an electrical
charge for up to 10 minutes after being
disconnected from the power source. To
reduce the risk of being shocked, wait at
least this long before working on capaci-
tors.
EXPERIENCING DIFFICULTIES. If you
are experiencing difficulties understand-
ing the information included in this sec-
tion, contact our Technical Support at
(570) 546-9663.
Model T27139 (Mfd. Since 3/16)
DAMAGE .
Some
Advertisement
Table of Contents
