Page 2
This manual provides critical safety instructions on the proper setup, operation, maintenance, and service of this machine/tool. Save this document, refer to it often, and use it to instruct other operators. Failure to read, understand and follow the instructions in this manual may result in fire or serious personal injury—including amputation, electrocution, or death.
Operating tools in when operating or observing machinery to these areas greatly increases risk of acci- reduce the risk of eye injury or blindness dents and injury. from flying particles. Everyday eyeglasses are not approved safety glasses. Model T28062 (Mfd. Since 08/17)
Page 4
FORCING TOOLS.. Use right tool for job, forming the intended operation, stop and do not force it. It will do job safer and using the machine! Contact our Technical better at rate for which it was designed. Support at (570) 546-9663. Model T28062 (Mfd. Since 08/17)
Page 5
Use this and other machinery with caution and respect. Failure to do so could result in serious personal injury, damage to equipment or poor work results. Model T28062 (Mfd. Since 08/17)
T28062 we used when writing this manual. However, Grizzly Technical Support sometimes we still make an occasional 1815 W.
Page 7
AC Adapter Spindle Lock Button ON/OFF/Variable-Speed Control Dial Knurled Collet Nut Figure 1. T28062 Component identification. To reduce your risk of serious injury, read this entire manual BEFORE using tool. Model T28062 (Mfd. Since 08/17)
Use this and other machinery with caution and respect. Failure to do so could result in serious personal injury, damage to equipment or poor work results. Model T28062 (Mfd. Since 08/17)
ON and adjust to low RPM. Verify —Medium ...........5 motor operation. —Coarse ..........5 G. AC Adapter ........1 5. Make sure tool runs smoothly and with- H. Case (not shown) .......1 out unusual problems or noises. 6. Turn ON/OFF/Variable-Speed Control dial OFF. Model T28062 (Mfd. Since 08/17)
SECTION 4: OPERATIONS Rotary Tool Use Use low RPM settings when work- ing with plastics or other materials The Model T28062 is best suited for high- with low melting points. Melted RPM, low-torque applications. Most opera- plastics can liquefy, be thrown into...
Page 11
& Bits DO NOT use bits or cutters with a cutting surface larger than 1". The bit could break apart under the The Model T28062 uses bits, burrs, and stresses of high speed use caus- ing serious personal injury. mandrels with ⁄...
SECTION 5: MAINTENANCE Cleaning Cleaning the Model T28062 is relatively easy and should be done daily to prevent build up of dust and resins. Use an air hose or vacuum to remove excess wood chips and dust from the ven- tilation opening (see Figure 5).
3. Install correct-sized bit for rotary tool. (Page 9). Motor 1. Dirty or blocked motor vents. 1. Blow out and wipe down overheats. motor vents (Page 10). 2. Excessive workload. 2. Allow motor to cool; reduce workload. Model T28062 (Mfd. Since 08/17)
REPLACEMENT PARTS REF PART # DESCRIPTION REF PART # DESCRIPTION PT28062001 COLLET/MANDREL KIT PT28062003 ABRASIVE CONE KIT PT28062002 BIT/BURR KIT Model T28062 (Mfd. Since 08/17)
WARRANTY Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of maintenance.