Power Connection; Test Run - Grizzly T27139 Owner's Manual

Power Connection

After you have completed all previous
setup instructions the tool is ready to be
connected to the power supply.
To avoid unexpected startups or property
damage, use the following steps whenever
connecting or disconnecting the tool.
Connecting Power
1. Turn tool power switch OFF (O).
2. Insert power cord plug into a matching
power supply receptacle. Tool is now
connected to power source.
Figure 5. Connecting power.
Disconnecting Power
1. Turn tool power switch OFF.
2. Grasp molded plug and pull it com-
pletely out of receptacle. Do not pull by
cord as this may damage wires inside.
Figure 6. Disconnecting power.
-10
-

Test Run

DO NOT start tool until all preceding
setup instructions have been per-
formed. Operating an improperly set
up tool may result in malfunction or
unexpected results that can lead to
serious injury, death, or tool/prop-
erty damage.
Serious injury or death can result
from using tool BEFORE under-
standing its controls and related
safety information. DO NOT operate,
or allow others to operate, tool until
information is understood.
To test run tool:
1. Clear all setup tools away from tool.
2. Remove collet nut and collet.
3. Connect tool to power supply.
4. Turn tool ON, verify motor operation,
and then turn tool OFF. Tool should
run smoothly and without unusual
problems or noises.
Model T27139 (Mfd. Since 3/16)