Wiring Connection - Grizzly G0543 Instruction Sheet

Snap fit the grommet into the opening as
7.
shown in Figure 12. Make sure there is
enough slack in the wire between the switch
and the grommet before snapping the grom-
met into position.
Figure 12. Installing grommet.

Wiring Connection

To connect the motor cord to the motor:
Remove three of the four motor mounting
1.
bolts and swing the motor toward the rear
stand opening, as shown in Figure 13.
Wiring Junction Box
Figure 13. Motor positioned for easy access.
2. Remove the cover from the wiring junction
box.
G0500/G1018/G1018HW 8" Jointers
Make the motor connections in accordance
3.
with the wiring schematics that are located
on the motor label or those shown below in
Figure 14 or Figure 15, depending on which
voltage you decide to use.
NOTICE
If you plan to rewire your machine for 110V,
you must use a different switch!
Figure 14. 110V motor wiring schematic.
Figure 15. 220V motor wiring schematic.
Make sure the wiring connections are
4.
secure, then replace the wiring junction box
cover.
5. Swing the motor back into position and
replace the motor mounting bolts, but leave
them finger tight for now.
-17-