Table of Contents
Advertisement
Curved Trim Guide
The curved trim guide is used for trimming
curved surfaces, such as adding a deco-
rative edge to a round table or trimming
curved corners on a laminate counter top.
This guide is only used with the fixed base,
and with router bits that do not have guide
bearings.
To use curved trim guide:
1. DISCONNECT TOOL FROM POWER!
2. Slide trim guide onto base plate as
shown in Figure 12, set guide height,
and tighten height adjustment lock
knob.
Figure 12. Curved trim guide adjustments.
3. Loosen depth adjustment lock knob
and turn depth adjustment knob to
adjust depth of cut.
4. Follow
instructions
Operations on Page 13. Make a test
cut by sliding guide bushing along
edge of a scrap piece of wood.
5. Repeat Steps 1–4 until cut is correct
height and depth.
-14
-
The straight guide can be used for trim-
ming, cutting dadoes, straight dovetails,
and for cutting circles.
Only use router bits with no guide bearings
when using the straight guide.
Using
Trimming
1. DISCONNECT TOOL FROM POWER!
2. Slide straight guide onto base plate
Height
Adjustment
Lock Knob
Depth
Adjustment
Knob
Depth
Adjustment
Lock Knob
3. Loosen wing nut and position straight
4. Follow
Routing
in
5. Repeat Steps 1–4 until cut is correct.
Straight Guide
Straight
as shown in Figure 13, then set guide
height and tighten lock knob.
— If using plunge base, straight guide
will attach to straight guide holder
(see Figure 1 on Page 5).
Lock
Knob
Figure 13. Typical straight guide
installation.
guide at approximately desired depth.
instructions
Operations on Page 13. Make a test
cut by sliding straight guide along
edge of a scrap piece of wood.
Model T27139 (Mfd. Since 3/16)
Guide
for
Wing
Nut
Routing
in
Advertisement
Table of Contents
