Checking The Tire Pressure; Checking The Torque Of The Wheel Nuts; Think Safety First; Using The Operator Platform Latching Mechanism - Toro CT2240 Operator's Manual

4. Remove the cap and fill the tank to the upper mark
on the sight level gauge.
Note: Do not overfill the tank.
5. Install the cap onto the tank.

Checking the Tire Pressure

Check the air pressure in the front and rear tires. Refer to the
chart below for the correct pressure.
Important: Maintain correct tire pressure in all tires to
ensure correct contact with the turf.
Tires Tire Type
Front Axle 23 x
10.5 - 12
BKT turf
pattern
Rear Axle 18 x 9.5 -
8 BKT turf
pattern
Checking the Torque of the
Wheel Nuts
Service Interval: Before each use or daily
Torque the wheel nuts to 200 N∙m (148 ft-lb) for the front
axle, and 54 N∙m (40 ft-lb) for the rear axle.
WARNING
Failure to maintain proper torque of the wheel nuts
could result in personal injury.
Ensure that the wheel nuts are torqued properly.

Think Safety First

Carefully read all safety instructions and symbols in the
safety section. Knowing this information could help you or
bystanders avoid injury.
Recommended Tire Pressures
Turf Road Maximum
Conditions Conditions Pressure
0.7 bar (10 1.4 bar (20 1.7 bar (25
psi) psi)
0.7 bar (10 1.4 bar (20 1.7 bar (25
psi) psi)
DANGER
Operating on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death, or
drowning.
There is no rollover protection when the roll bar is
down.
Always keep the roll bar in the fully raised and
locked position and use the seat belt.
Read and follow the rollover protection instructions
and warnings.
To avoid loss of control and possibility of rollover:
psi)
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than 20 degrees.
• Reduce speed and use extreme caution on
psi)
slopes.
• Avoid sudden turns or rapid speed changes.
CAUTION
This machine produces sound levels that can cause
hearing loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
Use protective equipment for your eyes, ears, hands, feet,
and head.
1
1. Wear eye protection.
Using the Operator Platform
Latching Mechanism
Do not operate the mower without first checking that the
operator platform latching mechanism is fully engaged and
in good working order.
23
G009027
Figure 27
2. Wear hearing protection.
2
g009027