Maintenance; Recommended Maintenance Schedule(S) - Toro CT2240 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Note: To obtain an electrical schematic or a hydraulic schematic for your machine, visit www.Toro.com.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 500 hours
Every 800 hours
Maintenance Procedure
• Check the condition and tension of the alternator belt.
• Change the engine oil and filter.
• Change the transmission oil filter.
• Change the hydraulic return filter.
• Check the engine speed (idle and full throttle).
• Check the engine-oil level.
• Check the cooling system.
• Check fuel level.
• Check the hydraulic-fluid level.
• Torque the wheel lug nuts.
• Check the tire pressure.
• Grease the bearings, bushings and pivots (grease them immediately after every
washing regardless of the interval listed).
• Check the air-cleaner blockage indicator (service the air cleaner earlier if the
air-cleaner indicator shows red; service it more frequently in extremely dirty or
dusty conditions).
• Remove debris from the screen, oil coolers, and radiator (more frequently in dirty
operating conditions).
• Check the safety interlock system.
• Check the hydraulic lines and hoses for leaks, kinked lines, loose mounting supports,
wear, loose fittings, weather deterioration, and chemical deterioration.
• Grease the bearings, bushings and pivots (grease them immediately after every
washing regardless of the interval listed).
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
• Change the engine oil and filter.
• Drain moisture from the fuel tank and the hydraulic-fluid tank.
• Check the condition of the battery.
• Check the condition of and clean the battery.
• Check the battery cable connections.
• Check the transmission control cable.
• Check the fuel lines and connections.
• Replace the fuel filter
• Check the engine speed (idle and full throttle).
• Check the engine overheat warning system.
• Replace the primary air filter (more frequently in extreme dusty or dirty conditions).
• Check the electrical system.
• Change the transmission oil filter.
• Change the hydraulic return filter.
• Check the rear wheel alignment.
• Service the hydraulic system.
• Check the hydraulic fluid overheat warning system.
• Replace the fuel filter.
• Drain and clean the fuel tank
• Adjust the engine valves (refer to the engine operator's manual).
31