Specifications; Attachments/Accessories; Operation; Checking The Engine-Oil Level - Toro CT2240 Operator's Manual

Specifications

Note: Specifications and design are subject to change without notice.
Specification
Transport width
Width of cut
Overall width
Length
Height
Weight
Engine
Fuel tank capacity
Transport speed
Mowing speed
Hydraulic system capacity

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand its
capabilities. Contact your Authorized Service Dealer or Distributor.
To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro genuine parts.
When it comes to reliability, Toro delivers replacement parts designed to the exact engineering specification of our equipment.
For peace of mind, insist on Toro genuine parts.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Lower the cutting units to the ground, engage the
parking brake, and remove the key from the ignition
switch before servicing or making adjustments to
the machine.
138.0 cm (54.3 inches)
212.0 cm (83.5 inches)
236.0 cm (92.9 inches)
286.0 cm (112.6 inches)
168.1 cm (66.2 inches) with ROPS folded
211.5 cm (83.3 inches) with ROPS in the vertical operating position
1240 kg (2733 lb)*
With fluids and 200 mm 6-blade cutting units
Kubota 19.5 kw (26 hp) at 3000 rpm DIN 70020
45 L (11.9 US gallons)
22 km/h (13.7 mph)
11 km/h (6.8 mph)
32 L (8.5 US gallons)

Checking the Engine-Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity: approximately 6.0 L (6.3 US qt) with
the filter
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or higher
•
Preferred oil: SAE 15W-40 (above 0 degrees F)
•
Alternate oil: SAE 10W-30 or 5W-30 (all temperatures)
Toro Premium Engine oil is available from your distributor in
either 15W-40 or 10W-30 viscosity.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
19
CT 2240