Toro CT2240 Operator's Manual page 43

Figure 53
1. Transmission bypass valves
8. The mower is now in a freewheel condition and can be
towed for a short distance at slow speed.
Note: Remove the wheel chocks before towing.
9. After towing the mower: To return the mower to its
normal working condition the following procedure
must be done:
A. Chock the front wheels.
B. Close the bypass valve on the transmission pump
by turning it clockwise.
10. Commission the front wheel motor disc brakes as
follows:
Note: Ensure that the M12 x 40 mm setscrews
and washers are removed and stored underneath the
operator platform.
A. Identify the right-hand front wheel motor disc
brake assembly.
B. Rotate the setscrew counterclockwise and remove
together with the washer.
C. Assemble the hex plug into the motor end plate
(Figure 54).
1
G014450
1. Front wheel moto
2. Hex plug
D. Identify the left front wheel motor disc brake
g014450
assembly and repeat the previous procedure.
E. Remove the wheel chocks.
F. Disconnect the tow bar.
Note: The mower braking system will now
operate normally.
WARNING
Operating the machine without brakes could result
in serious personal injury.
Before using the mower, ensure that the braking
system operates correctly. Carry out initial
checks with the mower at slow speed. Do not
operate the mower with a damaged braking
system. Do not operate the mower with the brakes
decommissioned.
43
1
2 3
Figure 54
3. Washer M12
4. Setscrew M12 x 40 mm
4
g014451
g014451