Changing The Rear-Pto-Gearbox Oil - Toro Outcross 9060 Series Operator's Manual

Figure 105
1. Drain port
2. Drain plug
2. Remove the drain plug from the drain port
(Figure 105).
Note:
Allow the oil to drain completely from the
brake housing.
3. Clean the threads of the plug.
4. Install the drain plug into the drain port
105).
5. Remove the fill plug at the top of the brake
housing (Figure 106).
Figure 106
1. Fill plug
2. Fill port
6. Fill the brake housing with 160 ml (5.4 fl oz) of
the specified oil through the fill port.
7. Install the fill plug into the fill port
g254599
3. Drain pan
4. Hydraulic brake
(Figure
g254600
3. Drain pan
(Figure 106).
Changing the
Rear-PTO-Gearbox Oil
Service Interval: After the first 150 hours
Every 1,500 hours/Yearly (whichever comes
first)—Change the rear PTO gearbox oil (when
the machine is used in normal conditions).
Every 1,000 hours/Yearly (whichever comes
first)—Change the rear PTO gearbox oil (when
the machine is used in dirty conditions).
Rear-PTO-gearbox oil specification: Toro Premium
Tractor Fluid
1. Remove the standard bed (if equipped) from
the machine; refer to
Standard Bed (page
2. Remove the plug from the sight port of the rear
PTO gearbox
1. Sight-port plug
3. Remove the plug from the drain port
108).
Note:
Allow the oil to drain completely from
the gearbox.
73
Removing or Installing the
35).
(Figure 107).
Figure 107
g256626
(Figure