Seat Leon Owner's Manual page 71

multifunction wheel pressed down for about 2
seconds.
Select the instructions
In the Infotainment system, in the menu Vehi-
cle settings, you can display different travel
›››
data page 87.
– The current
Current consumption:
fuel consumption display operates
throughout the journey, in litres/100 km;
and with the engine running and the ve-
hicle stopped, in litres/hour.
– The average
Average consumption:
fuel consumption is displayed after driv-
ing for approximately 300 metres.
– This indicates the
Travelling time:
hours (h) and minutes (min) since the ig-
nition was switched on.
– Approximate distance in km that
Range:
can still be travelled if the same driving
style is maintained.
– or Autonomy  : Ap-
Adblue Autonomy
proximate distance in km that can still be
travelled with the current level of the
AdBlue ® tank with the same driving style.
The indication appears from a range of
1) Not available in all countries.
2)
With an analogue instrument panel, the warn-
ings are always shown in white.
Instruments and warning/control lamps
less than 2,400 km and cannot be de-
activated. 1)
– Distance covered in km (m)
Distance:
after switching on the ignition.
– The average speed
Average speed:
will be shown after driving for approxi-
mately 100 metres.
– Current speed dis-
Digital speed:
played in digital format.
– Recommendations messag-
Eco tips:
es are shown to reduce consumption
through good driving practices, e.g. Air
conditioning on: close the win-
dow.
Oil and coolant temperature indication
(only with digital instrument panel)
The engine reaches its operating tempera-
ture when, under normal driving conditions,
the oil temperature is between 80°C and
120ºC. If the engine is under a lot of stress
and the outside temperature is high, the en-
gine oil temperature can increase. This does
not present any problem as long as the warn-
›››
ing lamps or page 296
 
pear on the display.
Warning and information messages
(Vehicle status)
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
Faults are displayed on the instrument panel
display as red and yellow warning symbols
accompanied by messages and, depending
on the case, even an audible warning
›››
page 80. The representation of the mes-
sages and symbols may vary depending on
the version of the instrument panel.
Existing faults can also be checked manually.
To do so, open the menu Vehicle info
›››
page 86.
Priority 1 warning (red)
The symbol lights up or flashes (in part ac-
companied by audible warnings).
driving! Danger! Check the fault and elimi-
nate the cause. If necessary, seek professio-
nal assistance.
Priority 2 warning (yellow)
do not ap-
The symbol lights up or flashes (in part ac-
companied by audible warnings). Operating
faults or the lack of operating fluids can
2)
Stop

»
69