Seat Leon Owner's Manual page 232

The driver should be ready to accelerate
●
or brake at all times.
Note
If the ACC does not work as described in
●
this chapter, do not use it until it has been
checked by a specialised workshop. SEAT
recommends visiting a SEAT dealership for
this purpose.
Maximum speed with the ACC activated
●
is limited to 210 km/h (130 mph).
When the ACC is switched on, strange
●
noises may be heard during braking,
caused by the braking system.
Symbols on the instrument panel
display and control lamps
3 Applies to vehicles with analogue instrument
panel
The speed reduction by the ACC
 to maintain the distance from the
vehicle in front is not sufficient.
Brake! apply the foot brake! Driver intervention
prompt.
230
Driving
The ACC is not currently availa-

ble.
While the vehicle is stationary, switch off the engine
and start it again. Perform a visual check of the radar
›››
sensor Fig. 164. If it is still unavailable, refer to a
specialised workshop to have the system inspected.
 The ACC is active.
No vehicle is detected in front. The programmed
speed remains constant.
If the symbol is white: the ACC is

active.
A vehicle in front has been detected. The ACC ad-
justs speed and distance from the vehicle in front.
If the symbol is grey: ACC is inac-

tive (Standby)
The system is switched on, but is not adjusting.
The lamp lights up green

The ACC is active.
Some control and warning lamps will light up
briefly when the ignition is switched on to
check certain functions. They will switch off
after a few seconds.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
Status display
On the instrument panel display:
Fig. 163
ACC inactive (Standby). ACC active.

›››
Indications on the display Fig.
Vehicle ahead detected. ACC is not ac-
1
tive and is not regulating your speed.
in Con-
81.

163: