Seat Leon Owner's Manual page 45

and request assistance from an authorised
technician.
Disconnect the air compressor. Unscrew
●
the tyre inflator tube from the tyre valve.
When the tyre pressure is between 2.5 and
●
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
›››
Attach the sticker Fig. 34
●
2
strument cluster, within the driver's visual
field.
Check the pressure again after 10 minutes
●
›››
page 43.
WARNING
When inflating the wheel, the air compres-
sor and the inflator tube may become hot.
Protect hands and skin from hot parts.
●
Do not place the hot flexible inflator tube
●
or hot air compressor on flammable mate-
rial.
Allow them to cool before storing the de-
●
vice.
If it is not possible to inflate the tyre to at
●
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
CAUTION
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid
overheating! Before switching on the air
compressor again, let it cool for several mi-
nutes.
Check after 10 minutes of driving
Screw the inflator tube
to the in-
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be
●
sealed sufficiently with the tyre mobility set.
You should obtain professional assistance
●
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
Set the tyre pressure to the correct value
●
again.
Carefully resume your journey until you
●
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
●
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious in-
jury.
Do not continue driving if the tyre pres-
●
sure is 1.3 bar (19 psi / 130 kPa) and lower.
Seek specialist assistance.
●
Self-help
›››
Fig. 34 again
5
.
6
Changing a wheel
What to do first
Park the vehicle on a horizontal surface and
●
in a safe place as far away from traffic as
possible.
Apply the electronic parking brake.
●
Switch on the hazard warning lights.
●
Manual transmission: select the 1st gear.
●
Automatic transmission: Move the selector
●
lever to position P.
If you are towing a trailer, unhitch it from
●
your vehicle.
›››
Have the vehicle tool kit page 40
●
›››
the spare wheel* ready page
Observe the applicable legislation for each
●
country (reflective vest, warning triangles,
etc.).
All occupants should leave the vehicle and
●
wait in a safe place (for instance behind the
roadside crash barrier).
WARNING
Always observe the above steps and pro-
●
tect yourself and other road users.
If you change the wheel on a slope, block
●
the wheel on the opposite side of the car
with a stone or similar to prevent the vehi-
cle from moving.
and
315.
43