Seat Leon Owner's Manual page 139

The red markings on the release buttons
should no longer be visible.
WARNING
Always secure objects, even when the
●
net partition is properly assembled.
There should be nobody behind the as-
●
sembled partition when the vehicle is mov-
ing.
The attachments on the backs of the rear
●
seats must never be used to fit the net par-
tition when the rear seat backs are in their
vertical position.
CAUTION
Incorrect handling of the net partition
could cause damage.
Do not "release" the net partition when
●
lowering it, as the net and other vehicle
parts could be damaged. Roll down the net
partition by hand.
Transport and practical equipment
Using the net partition while the
rear seat backs are folded down
3 Valid for: Leon Sportstourer
Assembling the net partition in the
Fig. 127
rear seat backrests.
In the luggage compartment: net par-
Fig. 128
tition hooked in place with the rear seat backs
folded down.
Fitting the net partition
Fold the rear seat backrests forward.
●
Remove the net partition from the side sup-
●
ports.
Place the net casing in the rail slots in the
●
›››
direction of the arrows Fig. 127
Push the casing towards the left side of the
●
vehicle in the direction of arrow
and as far as it will go.
Check that the net is secure.
●
Pulling out and securing the net partition
›››
Pull up handle Fig. 128
●
2
›››
net from the casing Fig. 128
Hook in the net partition on the right or left
●
›››
side Fig. 128 (magnified image).
3
Hook in the net partition into the housing on
●
›››
the other side Fig. 128 by pulling the
1
rod.
The net partition is properly assembled when
the T-shaped ends are firmly secured in the
›››
corresponding housings Fig. 128
.
1
Retracting the net partition
Remove the rod from the housings in the
●
trims of the roof side members.
Roll up the net into the casing
●
lowering it with your hand.
.
1
›››
Fig. 127
2
to remove the
.
4
and
3
›››
Fig. 128
4
»
137