Product Troubleshooting - Taylor C850 Manual

Problem
The product is undercooked or
overcooked.
The product is not cooking evenly.
Eggs are pooling to one side of the egg
ring.
The grill displays Lower Plate Stall, and
platen comes up.
The product is not recognized.

PRODUCT TROUBLESHOOTING

Probable Cause
The release material is dirty or worn.
The upper platen or lower cook surface
is not clean or has carbon buildup.
Incorrect cook time.
The grill's gaps are not within
specification.
The upper platen or lower cook surface
are not clean or have carbon buildup.
The release sheet material is dirty or
worn.
The grill's gaps are not within
specification.
The grill has become unlevel.
The grill's gaps are not within
specification.
The product being cooked is misshaped
or out of specification.
The wrong recipe was selected to cook.
Carbon buildup on the upper and/or
lower cook surfaces is interfering with
the Auto Gap settings.
The grill plate has become uneven.
The wrong product is being used.
The grill is not set in the Auto Product
Recognition mode.
75
Remedy
Clean and/or replace the release sheets.
Cleaning procedures must be followed
to properly clean the grill and remove
carbon buildup.
Increase or decrease the cook time
accordingly. See the Cook Time key on
page 33.
Refer to the gapping procedure in the
service manual.
Cleaning procedures must be followed
to properly clean the grill and remove
carbon buildup.
Clean and/or replace the release sheets.
Refer to the gapping procedure in the
service manual.
Level the grill.
Refer to the gapping procedure in the
service manual.
Press the STANDBY button again. The
product will flatten as it thaws.
Review and select the correct recipe
item. Restart the Cook cycle.
Remove the carbon and clean the upper
and lower cook surfaces.
Refer to the gapping procedure in the
service manual.
Ensure correct product and settings.
Ensure the grill control is set to Auto
Product Recognition mode.