Cleaning After Each Run Of Product (Not Using Lower Release Sheets) - Taylor C850 Manual

3. Push the residue into the grease trough.
Figure-88
4. Carefully squeegee the air bubbles from the center to
the side, making sure the release sheet does not
become folded or creased.
Figure-89
5. Wipe the squeegee with a sanitizer-soaked grill cloth.
Figure-90
6. Wipe the top platens and grill surface four times an
hour with a sanitizer-soaked grill cloth.
7. As needed during operation, use a sanitizer-soaked
grill cloth to clean the rear grease shield and the
bullnose areas. See Figure-92.
CAUTION! The upper platen surface and
release sheet are very hot. To prevent burn injuries, wear
heat-resistant gloves when replacing the release sheets.
CLEANING AFTER EACH RUN OF PRODUCT
(NOT USING LOWER RELEASE SHEETS)
Note: This manual contains separate procedures for
grills that use lower release sheets and for grills that do
not use lower release sheets. Use the appropriate
procedures for your grill.
If your grill uses lower release sheets, go to page 49.
50
Figure-91
Figure-92
30150_A
30151_A