Table of Contents
Advertisement
Programming:
Proceed as follows to program the wAppLoxx Pro Cylinder:
1. Click on "Program"
2. Present the "system card" at the cylinder. Green flashing will indicate successful
programming.
3. The cylinder will now connect to the wAppLoxx Pro Control. This process can take
several seconds.
4. Successful programming is confirmed by the following display, and you will be
prompted to turn the cylinder knob or to present a tag.
Programming the reset card
1. You can program the enclosed reset card under the system settings in the "System
access" menu item. Click on "Program reset card"
2. Then, present the enclosed reset card to the previously programmed cylinder.
3. Successful programming of the reset card is indicated when the cylinder flashes
green and the ID card is entered in the field.
4. Click on "Save".
5. The ID of the reset card is now transmitted to the programmed and all subsequently
programmed cylinders.
5.3 Programming a wall reader or a Bridge Box in the wAppLoxx Pro Control
To do this, please read all the relevant information in the Bridge Box operating instructions.
wAppLoxx Pro Control Complete Instructions
[20]
Advertisement
Table of Contents
