Table 2-8 Service Capabilities Of The Epico3801 - Huawei ePico3801 User Manual

ePico3801
User Guide
Item
Capacity
TX power
Diversity
Receiver sensitivity
Clock accuracy
Service Capabilities

Table 2-8 Service capabilities of the ePico3801

Item
Ordinary PS and CS services
HSPA
Issue 01 (2009–09–23)
Specification
Band II (1900 MHz)
Band V (850 MHz)
One carrier, one cell
In band I, the TX power is 100 mW (20 dBm). In band II and band
V, the TX power is 250 mW (24 dBm).
No transmit diversity or receive diversity
-110.0 dBm
±0.1 ppm after locking
NOTE
The ePico3801 model whose output power is 250 mW supports band II and band V only, and the ePico3801
model whose output power is 100 mW supports band I only. The RF board that supports band I and the
RF board that supports band II and band V have different TX powers. Band II and band V are supported
by the same RF board, which can be configured to support either band II or band V based on the actual
situation.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Introduction to the ePico3801
1850 to 1910
824 to 849
Specification
Supporting a maximum of 32 concurrent
UEs
Supporting a maximum of 32 concurrent
UEs that use CS services
Supporting a maximum of 16 concurrent
UEs that use PS services
The service combination of a single user can
be made up of a maximum of one CS service
and three PS services.
The maximum rate in HSDPA is 7.2 Mbit/s.
The maximum rate in HSUPA is 1.44 Mbit/
s.
Supporting a maximum of 8 concurrent UEs
that use HSPA services
Supporting concurrent 3GPP R99/R4/R5/R6
services
1930 to 1990
869 to 894
2-13