Checking The Software Version - Huawei ePico3801 User Manual

ePico3801
User Guide
4.
----End

4.4 Checking the Software Version

This chapter describes how to check the software version of the ePico3801.
Prerequisite
l
l
l
Procedure
l
l
----End
Issue 01 (2009–09–23)
If...
The test result of APM
LINK is Invalid or
TimeOut
Check the TSP Current State status.
If...
The TSP State status is
TransOK
The TSP Current
State status is NOK
NOTE
If the fault persists, contact the Huawei technical support engineers.
The network transmission between the ePico3801 and the AP Manager (APM) is normal.
The ePico3801 hardware is normal.
You have logged in to the WebUI through a computer.
Log in to the WebUI to check the software version of the equipment.
The software version is directly displayed in the upper right of the WebUI window.
Log in to the APM to check the software version of the equipment.
Choose Configuration > Single Configuration. In the Terminal Search area, enter the
relevant information of the equipment, and then click Search. The query result is displayed
in the Terminal List area.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description Then...
The
l
communication
between the
ePico3801 and the
APM fails.
l
l
Description Then...
The network End the check.
transmission is
normal.
The network Rectify the fault according to the
transmission is displayed fault cause of TSP Current
faulty. State.
4 Commissioning the ePico3801
Ensure that the transmission between
the ePico and the firewall and
between the firewall and the APM is
normal.
Ensure that the APM is installed with
the current version of the ePico3801.
Ensure that the IPsec tunnel between
the ePico and the firewall is
established successfully.
4-7