Configuring The Epico3801; Figure 3-1 Logging In To The Webui - Huawei ePico3801 User Manual

ePico3801
User Guide

Figure 3-1 Logging in to the WebUI

Step 3 In the dialog box, type the user name and password under User Name and Password
respectively. Then, click Login.
----End

3.2 Configuring the ePico3801

This chapter describes how to configure the ePico3801 on the WebUI when the ePico3801
accesses the network through the PPPoE dial-up or static IP address authentication mode.
Prerequisite
3.1 Logging in to the ePico WebUI
Issue 01 (2009–09–23)
NOTE
The user name is set to admin and cannot be changed. The default password is the last eight digits of the
APEI. The APEI is silk screened on the housing of the ePico. The system automatically prompts you to
change your password during the initial login. You must change your password before logging in to the
system normally.
If you fail to log in to the system after the maximum number of consecutive login failures (three times by
default) within the specified time (five minutes by default), the system is blocked for six hours by default.
You can unblock the account after the duration times out or press the RST button to reset the system. If
the duration of system unblocking is set to 0 on the AP Manager, it indicates that you must reset the ePico
for re-login when your account is locked.
Click Change password to change your password, The new password must meet the following conditions:
The new password must consists of 8 to 18 characters.
l
The new password cannot contain 3 or more consecutive same characters.
l
The new password must contain at least 3 combinations of a lower-case letter, upper-case letter, number,
l
and special character (such as ~!@#$%^*()-_=+\|[{}];:'",.>/?, and space).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
is complete.
3 ePico3801 Initial Configuration
3-3