Modifying 2G Macro Neighboring Cells - Huawei ePico3801 User Manual

5 Reconfiguring the ePico3801
Procedure
Step 1 Log in to the APM. Choose Configuration > Single Configuration and select an ePico3801 to
be maintained. Then, click Configure to enter the configuration window.
Step 2 Choose Terminal Parameter > WIRELESS > Configuration in the navigation tree to
configure the 3G macro neighboring cell parameters.
1.
2.
3.
4.
Step 3 After the parameter setting is complete, click Apply. A system message is displayed, indicating
whether the parameter setting is successful.
----End

5.4.2 Modifying 2G Macro Neighboring Cells

This chapter describes how to manually add 2G macro neighboring cells on the AP Manager
(APM). This operation can be performed only in manual network planning mode.
Prerequisite
l
l
Context
If the signal quality of a UE in an AP cell is poor, the UE needs to be handed over to a 2G inter-
RAT neighboring cell. In this case, the information about 2G neighboring cells needs to be
configured. If both the 2G and 3G neighboring cells exist, the UE is handed over to a 3G
neighboring cell by default. If you require the UE to be handed over to a 2G neighboring cell,
you need to run the HOCOMM command in the APM window to change the related parameter
setting. For details, see
to 3G Macro
5-6
NOTE
If the 2G inter-RAT neighboring cells also exist, however, the UE may be handed over to a 2G or 3G
neighboring cell. This is determined by the parameter setting. For details, see
ePico3801 Parameters Related to the Handover to 3G Macro
Choose NRNC to set the information about the neighboring RNCs.
Choose NRNCCELL to add, delete, or modify the cells controlled by the neighboring
RNCs.
Choose INTERFREQNCELL to add, delete, or modify the inter-frequency neighboring
cells.
Choose INTRAFREQNCELL to add, delete, or modify the intra-frequency neighboring
cells.
NOTE
The commands in Step
l
the neighboring RNCs is configured.
For details about how to set the parameters, see Help in the corresponding configuration window.
l
The parameters of the ePico zone have been set successfully.
You have logged in to the APM. The login account belongs to the Administrator or
Operators group.
5.4.5 Modifying the ePico3801 Parameters Related to the Handover
Cells.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2.2, Step 2.3, and Step 2.4
5.4.5 Modifying the
Cells.
can be executed only after the information about
Issue 01 (2009–09–23)
ePico3801
User Guide