Power/Water/Air Requirements - Lincoln Electric TORCHMATE 4400 Site Prep Manual

POWER/WATER/AIR REQUIREMENTS

Please refer to the FlexCut operators manual for complete installation and operation guidelines. Only a qualified electrician should
connect the input leads to the Torchmate 4400/4800/4510 CNC unit and FlexCut Plasma unit. Connections should be made in
accordance with all local and national electrical codes. Failure to do so may result in bodily injury or death.
The 4x00 table has a single 120v NEMA 5-15P plug that powers the table and computer/monitor.
The FlexCut 80 is rated for 208 VAC through 575 VAC input voltages, single or three phase and 50 or 60 Hz. The FlexCut 125 is rated
for 380 VAC through 575 VAC input voltage, three phase only and 50 or 60 Hz. Before connecting the machine to power, be sure the
input supply voltage, phase and frequency all match those listed on the machine rating plate.
The FlexCut 80 automatically senses and adjusts to work with any input voltage, phase or frequency listed on the rating plate. No
reconnect switch settings are required. The power supply cord is supplied without an attachment plug to accommodate single
phase or three phase installations.
Warning:
The FlexCut on/off switch is not
intended as a service disconnect
for this equipment. Only a
qualified electrician should
connect the input leads to the
Torchmate 4400/4800/4510.
The Torchmate 4400/4800/4510 CNC machine requires clean, dry, oil-free compressed air or nitrogen. A high pressure
regulator MUST be used with a compressor or high pressure cylinder.
Supply pressure must be between 87-110 psi (6-7.6 bar) with flow rated rates of at least 300 SCFH or 140 SLPM.
AIR SUPPLY PRESSURE SHOULD NEVER EXCEED 110 PSI OR DAMAGE TO THE MACHINE MAY OCCUR!
A standard nominal 5 micron in-line filter is recommended, but for optimal performance, select a pre-filter with a 3 micron
absolute rating. Air must be supplied to the plasma with 3/8" inside diameter tubing and 1/4 NPT quick disconnect coupler.
Air lines should be run as to not create a trip hazard. We recommend using the TMS-214-0000-00 approved air filtration
assembly, available from
Water should be installed in the table pan before operation. Rust inhibitors such as non-sodium nitrite based products may
be used as a corrosion inhibitor in CNC plasma water tables. Operators are encouraged to use Lincoln Electric® PlateGuard
Visit www.torchmatestore.com
Water Capacity
• 4400 models hold approximately 60 gallons or 230 liters.
• 4800 models hold approximately 107 gallons or 405 liters.
• 4510 models hold approximately 140 gallons or 530 liters.
Site Prep Guide
www.torchmatestore.com
to purchase.
Page vii
.
TM