Power/Air/Water Requirements - Lincoln Electric Torchmate 5100 Series User Manual

Power/Air/Water Requirements and Installation (non-HD)
Please refer to the FlexCut/Spirit II operators manual for a complete installation and operation guidelines. Only a quali-
fied electrician should connect the input leads to the Torchmate 5100 CNC unit and FlexCut/Spirit II Plasma unit. Con-
nections should be made in accordance with all local and national electrical codes. Failure to do so may result in bodily
injury or death.
The FlexCut 125/200 is rated for 380 VAC through 575 VAC input voltage, three phase only and 50 or 60 Hz. Before
connecting the machine to power, be sure the input supply voltage, phase and frequency all match those listed on the
machine rating plate.
The Burny Kaliburn Spirit II plasma cutters are manufactured to the customer's power availability.
The power supply cord is supplied on the FlexCut 125 without an attachment plug to accommodate three phase instal-
lations of being hard wired to a disconnect or for a wall plug. FC200/Spirit II do not include SO cord for connection to
customers power and will need to have the appropriate cable connected per electrical requirements.
Warning:
The FlexCut on/off switch is not
intended as a service disconnect
for this equipment. Only a
qualified electrician should
connect the input leads to the
Torchmate 5100.
The Torchmate 5100 CNC machine requires a clean, dry, oil-free compressed air. A high pressure regulator MUST be used
with a compressor or high pressure cylinder.
Supply pressure must be between 87-110 psi (6-7.6 bar) with flow rated rates of at least 300 SCFH or 140 SLPM.
AIR SUPPLY PRESSURE SHOULD NEVER EXCEED 130 PSI OR DAMAGE TO THE MACHINE MAY OCCUR!
A standard nominal 5 micron in-line filter is recommended, but for optimal performance, select a pre-filter with
a 3 micron absolute rating. Air must be supplied to the plasma with 3/8" inside diameter tubing and 1/4 NPT quick
disconnect coupler. Air lines should be run as to not create a trip hazard.
Water should be installed in the table before operation. Operators are encouraged to use a readily available
anti-corrosive water additive designed for use in CNC plasma water tables.
Water Capacity: 428 gallons (1620 liters)
To Plasma Power Supply
9
120v to Machine
User Guide