Re-Calibrating The Thermostat; Error Codes - Polypipe SmartStat Manual

Re-calibrating the Thermostat

If you need to re-calibrate the thermostat, follow these steps.
• Use the Left / Right keys to scroll to the
• Press and hold Tick to turn the display OFF ..........................................................
• Press and hold the Tick and Down keys together for 10 seconds .................
• The current temperature will appear on the display.
• Use the Up / Down keys to con gure the new temperature value .............
• Press the Tick key to con rm the change and the display will go blank ....
• Press the down arrow to highlight the
• Press the Tick key once to turn the thermostat ON ............................................

Error Codes

When terminated for thermostat operation the screen will display an error code if a fault
is detected.
E0 = The internal sensor has developed a fault.
E1 = The remote FLOOR probe has not been connected.
The remote FLOOR probe has not been wired correctly.
The remote FLOOR probe is faulty.
E2 = The remote AIR probe has not been connected.
The remote AIR probe has not been wired correctly.
The remote AIR probe is faulty.
27
.............................................
.............................................................
Smart Series