Related Manuals for Polypipe UFHBOOSTWP
Summary of Contents for Polypipe UFHBOOSTWP
- Page 1 User’s manual User’s manual UFHBOOSTWP UFHBOOSTWP Room Thermostat Room Thermostat www.polypipeufh.com...
-
Page 2: Table Of Contents
User’s manual Table of contents Safety Description III. Installation How to use the controller How to register the room sensor in a particular zone How to change the pre-set temperature... -
Page 3: Safety
UFHBOOSTWP I. Safety Before using the device for the fi rst time the user should read the following regulations carefully. Not obeying the rules included in this manual may lead to personal injuries or controller damage. The user’s manual should be stored in a safe place for further reference. -
Page 4: Description
User’s manual Description UFHBOOSTWP room thermostat is intended for cooperation with UFH8ZMP wiring Centre. UFHBOOSTWP room thermostat are installed in particular heating zones. Temperature information sent by them to the external controller is used to control the thermostatic valves (by opening them when the room temperature is too low and closing them when the pre-set room temperature has been reached). -
Page 5: How To Use The Controller
UFHBOOSTWP How to use the controller How to use the controller 1. Light sensor 2. Display – current zone temperature 3. Diode informing about reaching the pre-set zone temperature (steady on) or the zone temperature being too low (fl ashing) 4. - Page 6 Each room thermostat should be registered in one zone. Enter UFH8ZMP wiring Centre menu and select Sensor in the submenu of a given zone (Zone/Registration/Sensor). Select Registration and press communication button on UFHBOOSTWP temperature thermostat. Communication button If the registration process has been completed successfully, the UFH8ZMP display shows an appropriate message whereas the room thermostat display shows “Scs”.
-
Page 7: How To Change The Pre-Set Temperature
UFHBOOSTWP How to change the pre-set temperature The pre-set zone temperature may be adjusted directly from UFHBOOSTWP room thermostat using PLUS and MINUS buttons. During controller inactivity, the main screen displays current zone temperature. After pressing PLUS or MINUS, the current temperature is replaced with the pre-set temperature (the digits are fl... - Page 8 Polypipe Building Products Broomhouse Lane Edlington Doncaster DN12 1ES +44 1709 770000 www.polypipeufh.com...
Need help?
Do you have a question about the UFHBOOSTWP and is the answer not in the manual?
Questions and answers