Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Crestron CWD7787
Summary of Contents for Crestron CWD7787
- Page 1 Crestron CWD7787 Two-Way RF Transceiver Operations Guide...
- Page 2 This document was prepared and written by the Technical Documentation departmentat: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 3 Crestron CWD7787 Two-Way RF Transceiver Operations Guide ©2019Crestron Electronics, Inc.
-
Page 5: Table Of Contents
Crestron CWD7787 Two-Way RF Transceiver Contents Two-Way RF Transceiver: CWD7787 ............1 Functions and Features ......................1 Specifications ..........................2 Physical Description ........................2 Setup ............................4 Labeling ............................. 4 Documentation ........................... 5 Operations Guide - DOC. 7787A Contents • i... -
Page 7: Two-Way Rf Transceiver: Cwd7787
The transceiver operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices. The transceiver receives RF signals from one or more Crestron devices and can transmit these signals over the air for further processing (depending on the application). -
Page 8: Specifications
RF interference, multiple transceivers operating at the same frequencies should not be installed within 3-5 feet of each other. Physical Description The transceiver, shown below, consists of various components attached to a printed circuit board. Physical View of CWD7787 Ttop, Bottom, Side) 2 • Two-Way RF Transceiver: CWD7787 Operations Guide - DOC. 7787A... - Page 9 The RF Circuitry is powered through the MC4 which is connected to a PoE Power over Ethernet connector. Antenna connection is made via a reverse SMA connector. Refer to the pictures that follow for PoE and antenna connections PoE connection Antenna Connection Operations Guide - DOC. 7787A Two-Way RF Transceiver Transceiver: CWD7787 • 3...
-
Page 10: Setup
étiquette faisant référence au transceiver inclus. Cette étiquette extérieure peut utiliser les libellés suivants: « le transceiver de transmetteur IC: 5683C-CWD7787» ou « le IC: 5683C-CWD7787». Tout libellé similaire exprimant le même sens peut être utilisé. 4 • Two-Way RF Transceiver Transceiver: CWD7787... -
Page 11: Documentation
L’exploitation est autorisée aux deux conditions suivantes : L’appareil ne doit pas produire de brouillage; L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Operations Guide - DOC. 7787A Two-Way RF Transceiver Transceiver: CWD7787 • 5... - Page 12 This page intentionally left blank Crestron Electronics, Inc. Operations Guide – DOC. 7787A 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Two-Way RF Transceiver Fax: 201.767.7576 Transceiver: CWD7787 www.crestron.com Specifications subject to change without notice.
Need help?
Do you have a question about the CWD7787 and is the answer not in the manual?
Questions and answers