Table of Contents
Advertisement
Chapter 4 Using the DF HAND FEED KIT
At maximum three sheets of paper can be simultaneously folded together by using the DF HAND FEED KIT.
1.
Applicable Paper and Folding Mode
1-1.
Paper to be used
Paper size: A4,B5 (For EU)/LTR (For NA)
Thickness of paper: 52.3 to 81.4 g/m
The number of paper to be folded: Maximum three sheets of paper. Fine quality short grain paper
2
64 g/m
/43.52 lbs or less, art paper, two sheets of coated paper or less
• Do not use a smaller type of paper than specified. Paper jam may occur inside this machine
by using other type of paper and a trouble may be caused.
• The number of sheets out of the range above cannot be processed, and thinner or thicker
sheets cannot be used. Deformed folding may be performed, and paper jam may occur in this
machine by processing more sheets, or using thinner or thicker sheets than specified, and a
trouble may be caused.
1-2.
Folding modes
• Single fold
• Letter fold
• Accordion-fold
When performing letter fold of thick paper,
the folded paper opens at the ejecting
section, and it cannot be conveyed under
the stacker roller, which may result in an
error.
Using A3 or B4 size single folded paper (cross fold)
Cross fold is available only for a single fold
sheet. More than one sheet of single fold
paper cannot be used.
Press the folded section firmly and perform
paper folding operation. The paper feeding
state will be unstable if the folded line is not
folded firmly.
• Folded paper may result in Σ dent
depending on the paper type and stretch of
the folded section. This is not a malfunction
of the machine.
• When folding single-folded paper by
manual feeding, folding may not be
completed properly depending on the
paper thickness and stiffness at the folded
section. Check in advance using the paper
to be used.
2
/35.56 to 55.35 lbs
Copyright © 2019 Duplo Corporation All Rights Reserved
Chapter 4 Using the DF HAND FEED KIT
Single fold
Letter fold
Accordion-fold
∑ dent
75
Advertisement
Table of Contents
