IDVille ID Maker Apex Getting Started Manual page 42

ERROR TEXT DISPLAYED
ON PRINTER
13 INTERNAL ERROR
42
ERROR DESCRIPTION
12:3 While feeding a card from the
hopper, the front sensor
blocked before the mid one.
12:4 While feeding a card from the
hopper, the front sensor
blocked before the rear one.
12:5 While trying to feed a card from
the hopper, the mid sensor
triggered before the front one.
13:1 The printhead took too long to
reach a temperature suitable
for printing. There may be a
fault with the printhead
temperature sensor.
13:2 The mag PCB MCU reported
that an error occurred while
trying to carry out an operation
or interpret a command.
13:3 The mag driver reported that
an error occurred while trying
to carry out an operation.
13:4 Communication with the print
engine microcontroller failed.
If rebooting the printer does
not x this problem, try
updating the rmware. If that
does not work, there is
probably a hardware fault.
ID C rd Printer - User
SOLUTION BY CATEGORY
nu l