IDVille ID Maker Apex Getting Started Manual page 33

ERROR TEXT DISPLAYED
ON PRINTER
ERROR DESCRIPTION
4:14 While moving the card from the
rear sensor to the standby
position, it took too long for the
rear sensor to unblock.
4:15 While moving a card from the
ipper into the smart encoder, it
took too long for the smart
extract sensor to trigger. This
may mean that there is no
encoder actually tted.
4:16 While feeding a card past a
sensor, and having seen the
card reach that sensor, it took too
long to unblock.
4:17 While moving the card into
position for a printing or
encoding operation, it took too
long for the reference edge of
the card to move in front of the
sensor used for positioning. In
the case of extended mono
prints, this means the mid
sensor took too long to block.
In other cases, this means it took
too long for the rear sensor to
unblock.
4:18 While moving the card into
position for a printing or
encoding operation, it took too
long for the reference edge of
the card to move behind the
sensor used for positioning. In
the case of extended mono
prints, this means the mid-
ID C rd Printer - User
SOLUTION BY CATEGORY
nu l
33