EMS FirePoint 5000 Communications Manual page 15

EMS 5000 FIREPOINT
21 Now press the "NO" key and the screen will display:
22 Now press the "NO" key and the screen will display:
23 Now press the "" button until the screen displays:
24 Now press the "YES" key and the screen will display:
Press the "" button until the screen displays:
25
26 Press the "YES" key and the screen will display:
27 The Rem Rxer should be set to "DISABLED", press the
"YES" key to change its status. Once set to "Enabled"
press the "NO" key. The screen will display:
Now press the "" button and the screen will display:
28
Press the "YES" key and the screen will display:
29
30 The collector should be set to "ENABLED", press the
"YES" key to change its status. Once set to "Enabled"
press the "NO" key. The screen will display:
31 Press the "NO" key and the screen will display:
©2015 EMS Security Group Ltd. All rights reserved.
15
| Bus Master Setup |
> Bus Remote Setup<
| Pager232 Redir'
Yes= Select Time
| System Support
> Serial Comms
| Pager Setup
Yes= Select Time
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select Time
| * Remote Receivers*|
>Receivers Found
| Enable Receiver
Yes= Select Time
| Receivers Found |
> Enable Receiver <
| Enable Collector |
Yes= Select Time
Rem Rxer : ENABLED
Push YES to change
Push NO to escape
Yes/No Time
| Receivers Found |
> Enable Receiver <
| Enable Collector |
Yes= Select Time
| Enable Receiver
>Enable Collector <
| Monitor Traffic
Yes= Select Time
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select Time
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select Time
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select Time
TSD233 Iss 3 25/06/15 AJM
|
|
<
|
|
<
|
<
|
|
|
|
<
|