Slave Panel Step By Step Software Configuration - EMS FirePoint 5000 Communications Manual

EMS 5000 FIREPOINT

9. Slave Panel Step By Step Software Configuration

Note: it is assumed that all installation procedures are complete.
Now, at the slave panel, insert the Key into the Panel's Control Keyswitch, located at the
right of the Panel. Turn the Key to the "ON" Position.
Step
No
1 Press the "0" key followed by the "" button until the
screen displays:
2 Press the "YES" key and the screen will now display:
3 Press the "" button until the screen displays:
4 Press the "YES" key and the screen will now display:
5 Enter 221100 then press the "YES" key and the screen
will now display:
6 Press the "" button until the screen displays:
7 Press
the Keypad the screen will now display:
8 Press the "" button until the screen displays:
9 Press the "YES" key. The screen will
©2015 EMS Security Group Ltd. All rights reserved.
Action
the "YES" key
Screen Display
followed "0" key
now display:
13
| Logging
>Fire System Opts<
| ^^^^^^^^^^^^^
Yes = select
Time
| ** Fire system ** |
>Dev. Disable/Test<
| Net. Disable/Test
Yes= Select
| System Mode
>Engineers Config <
| Printer Options
Yes= Select
Enter Your PIN
For Access>
Then Press YES
| ** Eng. Config ** |
> Device Database <
| Sounder Options |
Yes= Select
| Reset Security
> Reset System
| Lan Options
Yes= Select
| ** Main Menu ** |
on
>Pins & Access
| System Support
Yes= Select
| System Support
> Serial Comms
| Pager Setup
Yes= Select
|* Serial Comms *|
>Device Table
| Re-start bus
Yes= Select
TSD233 Iss 3 25/06/15 AJM
|
|
|
Time
|
|
Time
Time
Time
|
<
|
Time
<
|
Time
|
<
|
Time
<
|
Time