EMS FirePoint 5000 Communications Manual page 11

EMS 5000 FIREPOINT
32 The collector should be set to "ENABLED", press the
"YES" key to change its status. Once set to "Enabled"
press the "NO" key. The screen will display:
33 Press the "NO" key and the screen will display:
34 Press the "" button until the screen displays:
35 Press the "YES" key and the screen will display:
36 Press the "YES" key and the screen will display:
37 Enter "00" followed by the "YES" key unless the NUA is
already set to 00. In which case press the "NO" key.
The screen will display:
38 Press the "" button until the screen displays:
39 Press the "YES" key and the screen will display:
40 The Routing should be set to "ENABLED". If already
set, press the "NO" key. (If "DISABLED" press the
"YES" Key followed by the "NO" key. The screen
should now display:
41 Press the "NO" key and press the "" button until the
screen displays:
42 Press the "YES" key and the screen will display:
©2015 EMS Security Group Ltd. All rights reserved.
11
| Enable Receiver
>Enable Collector <
| Monitor Traffic
Yes= Select Time
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select Time
| Checksum Data
> Network Router <
| Radio Lan
Yes= Select Time
| *
NETWORK ROUTER
>Setup local NUA
| View network NUA
Yes= Select Time
Local NUA : 00
Input Local NUA
Yes= Finish Time
| *
NETWORK ROUTER
> Setup local NUA
| View network NUA |
Yes= Select Time
| Network Name
> Control Routing
| Send Test
Yes= Select Time
Routing : DISABLED
Push YES to change
Push NO to escape
Yes/No Time
| Network Name
> Control Routing
| Send Test
Yes= Select Time
| Radio Lan
> Fire DB
|^^^^^^^^^^^^^^^^ |
Yes= Select Time
| *** Lan Fire DB ***
> H/W Local Panels <
| Mimic
Yes= Select Time
TSD233 Iss 3 25/06/15 AJM
|
|
|
<
|
|
|
*|
<
|
*|
<
|
<
|
|
<
|
|
<
|
|