EMS FirePoint 5000 Communications Manual page 10

EMS 5000 FIREPOINT
21 Press the "" button and the screen displays:
22 Press the "YES" key and the screen will display:
23 Whilst the remote port is set to 0, press the "NO" key.
Otherwise, enter 0, then press the "YES" key. The
screen will display:
24 Press the "NO" key twice and the screen will display:
25 Press the "" button until the screen displays:
26 Press the "YES" key. The screen will now display:
27 Press the "" button until the screen displays:
28 Press the "YES" key and the screen will display:
29 The Rem Rxer should be set to "DISABLED", press the
"YES" key to change. Once set to disabled press the
"NO" key. The screen will display:
30 Press the "" button and the screen will display:
31 Press the "YES" key and the screen will display:
©2015 EMS Security Group Ltd. All rights reserved.
10
| Reply Baudrate
> Port To Use
| ^^^^^^^^^^^^^^^^|
Yes= Select Time
Remote Port = 0
0 = Off, 1 = RS485
2 = PAGER 232> _
Yes= Select Time
| Reply Baudrate
> Port To Use
| ^^^^^^^^^^^^^^^|
Yes= Select Time
| System Support
> Serial Comms
| Pager Setup
Yes= Select Time
| Logging
>Remote Rxers
| Ext. Comms
Yes= Select Time
|* Remote Receivers *|
>Receivers Found <
| Enable Receiver
Yes= Select Time
| Receivers Found
>Enable Receiver <
| Enable Collector
Yes= Select Time
Rem Rxer : ENABLED
Push YES to change
Push NO to escape
Yes/No Time
| Receivers Found |
> Enable Receiver <
| Enable Collector |
Yes= Select Time
| Enable Receiver
>Enable Collector <
| Monitor Traffic
Yes= Select Time
Collector: ENABLED
Push Yes to change
Push No to escape
Yes= Select Time
TSD233 Iss 3 25/06/15 AJM
|
<
|
<
|
<
|
|
<
|
|
|
|
|
|