Booster Car Seat Installation With Canopy Use - Baby Trend Cover Me CV89 Owner's Manual

6.0 Installation and Use - Booster Mode

6.8 Booster Car Seat Installation with Canopy Use

1. Remove harness and buckle from car seat.
(See section 6.3 page 93) for removal of
harness and buckle.
2. Adjust booster car seat to recline position 5.
(See section 5.15 page 68) for base recline.
NOTE: The base recline must be in
position 5 while in booster car seat
mode. NEVER use rear-facing recline
foot in booster car seat mode.
3. Place Booster car seat in an automobile
seat with a Lap/Shoulder belt and does
not have an active Frontal airbag.
If the vehicle seat back is adjustable,
adjust into the upright position or the
position specified in the vehicle owner's
manual for use with a car seat (Fig. 89a).
4. Locate the the canopy mechanism on the
intended use, lap/shoulder belt use side
(Fig 89b).
5. Temporarily remove both canopy hoops on
the lap/shoulder side (Fig. 89c) and feed
the shoulder belt through the shoulder belt
positioner guide and replace the canopy
hoops. The shoulder belt webbing will
be routed between the Booster car seat
and the canopy (Fig. 89d).
89
Fig. 89a
Fig. 89b
Fig. 89d
Fig. 89c
Copyright © 2020, Baby Trend, Inc.
6.0 Installation and Use - Booster Mode
6.8.1 Booster Car Seat Installation with Canopy Use Continued
6. Thread shoulder belt into the
lower slot of Booster Shoulder
Belt Guide located on the
underside of the Head Support.
- Slide shoulder belt into open
end of slot, around Belt
Retainer Tab and into Inner Slot
of Head Support (Fig. 90a).
NOTE: Vehicle shoulder belt
must slide freely in Booster
Shoulder Belt Guide.
7. Place child in Booster Car Seat
with child's back and rump
contacting seating surfaces
(Fig. 90b).
Copyright © 2020, Baby Trend, Inc.
5
Upper Shoulder
Belt Path
Lower Shoulder
Belt Path
Fig. 90a
Fig. 90b
90