Baby Trend Cover Me CV89 Owner's Manual page 18

5.0 Installation and Use
3. Locate rear facing belt path openings
(Fig. 33a).
4. Remove both cup holders by pressing
the retention tab and set to the side
(Fig. 33b).
5. Pull the seat fabric back and route
LATCH Lower Anchor J-Hook connector
through the rear facing belt paths.
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing
the car seat to the vehicle
6. Attach the lower J-hook connector to the
vehicle anchor used for LATCH. Place
your hand in the seat and push down
while pulling on the free end of
Anchor J-Hook to tighten (Fig. 33d).
33
Internal Harness Mode
Fig. 33a
Fig. 33b
(Fig. 33c).
Fig. 33c
Lower
Fig. 33d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
7. Pull up on each Lower Anchor J-Hook
connector to ensure the lower anchor
j-hook is securely fastened.
8. Reinstall the cup holders. Please note LH
or RH on bottom of cupholder. LH or RH
refers to child's right and left (Fig. 34a).
9. Pull seat fabric back over each cup holder
(Fig. 34b), and then front of seat to secure
(Fig. 34c).
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig.34a
Fig. 34b
Fig.34c
34