Rear Facing Installation With Latch Lower Anchor - Baby Trend Cover Me CV89 Owner's Manual

5.0 Installation and Use
10. Ensure the angle indicator bubble is
centered between the lines for children
4-22 lbs. (1.81 - 9.97 kg) to keep the
child's airway open. Ensure the angle
indicator line is level with the ground for
children 23-40 lbs (10.43 - 18.14 kg) to
keep the child's airway open (Fig. 31a).
11. Check for movement of the car seat
at the safety belt path. The car seat
should not move more than 1 inch in
any direction. If the car seat moves
more than 1 inch, repeat all steps until
all safety steps are met (Fig. 31b).
12. Place child in seat and secure harness.
Recheck angle indicator to confirm the
angle with the appropriate indicator
by weight.
13. Repeat steps if necessary, after
securing child.
31
Internal Harness Mode
Level this line with the ground
for children greater
than 22 lbs. (10 kg)
Center bubble for
children4 -22 lbs.
CV0107052419
Fig. 31a
Lap Belt
Fig. 31b
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use

5.4 Rear Facing Installation with LATCH Lower Anchor

Requirements. See section 2.1:
• Weight is 4 - 40 lbs (1.81 - 18.14kg).
• Height 1" from top of seatback.
LATCH
Lower Anchor
Place this car seat in a rear seating position designated as LATCH Lower
Anchor compatible. Refer to your vehicle owner's manual for LATCH locations.
1. Extend the flip foot into position and ensure
lock is engaged. To adjust the angle of the
seat lift the recline handle. Use positions
for Rear facing (Fig. 32a).
Angling the car seat will keep the baby's head
back and airway open.
2. Make sure vehicle is parked on level ground then, place the car seat
in a rear seating position and ensure vehicle is level.
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
1-3
3

Fig. 32a
32