Baby Trend Cover Me CV89 Owner's Manual page 16

5.0 Installation and Use
3. Locate rear facing belt path openings
(Fig. 29a).
4. Remove cup holder by pressing the
retention tab and set to the side (Fig. 29b).
5. Pull the seat fabric back and route Lap Belt
through the rear facing belt paths.
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing the
car seat to the vehicle (Fig. 29c).
6. Insert the lap belt buckle tongue into the
buckle. Place your hand in the seat and
push down on the seat while pulling up the
lap belt to tighten (Fig. 29d).
29
Internal Harness Mode
Fig. 29a
Fig. 29b
Fig. 29c
Fig. 29d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
7. Pull up on buckle to ensure the
buckle is secure.
8. Reinstall cup holder. Please note
LH or RH on bottom of cupholder.
LH or RH refers to child's right and
left (Fig. 30a).
9. Pull seat fabric back over each cup
holder (Fig. 30b), and then front of
seat to secure (Fig. 30c).
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig.30a
Fig. 30b
Fig.30c
30