Installation And Use Internal Harness Mode - Baby Trend Cover Me CV89 Owner's Manual

5.0 Installation and Use
The American Academy of Pediatrics and Baby Trend recommend
children remain in a rear-facing car seat as long as possible, until
they reach the highest weight or height allowed by their seat.
DEATH or SERIOUS INJURY can occur:
• Use only in a rear facing position when using the car seat with an
infant weighing less than 22 lbs. (9.97kg).
• Use only with children who weigh between 4 - 65 lbs.
(1.81 - 29.48 kg) and whose height is 50 inches (127 cm) or less.
Forward facing 1 year and 23 - 65 lbs. (10.43 - 29.48 kg).
• Snugly adjust the belts (Harness) provided with the car seat
around your child. Snug means you can not pinch webbing
once buckled.
• Secure the top anchorage strap provided with this car seat.
• Secure this child seat with the vehicle's child restraint Anchorage
system (LATCH) if available or with a lap/shoulder belt.
• Follow all instructions on the car seat and in the written
instructions located under the cover. Do not use without
instructions. Call 1-800-328-7363 to obtain instructions.
• Use vehicles seat belt (not LATCH) for children weighing more
than 45 lbs (20.4 kg).
• Register your car seat with Baby Trend.
• DO NOT place rear facing child seat in a front seat that has an
active airbag.
• NEVER leave child unattended under any circumstance.
• DO NOT use the lower anchors of the child restraint anchorage
system (LATCH system) to attach this child restraint when
restraining a child weighing more than 45 lbs (20.4 kg).
21
Internal Harness Mode
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
5.1 Child Placement in The Car Seat - Internal Harness Mode
1. Place child in the car seat with the child's back flat against the back
of the car seat and the child's bottom touching the seat.
2. Place harness straps over the child's shoulders.
NOTE: Check the height of the harness straps at the child's
shoulders.
3. Place the crotch buckle in appropriate position.
page 69.
4. Insert the buckle tongues into the crotch buckle.
NOTE: Pull up and test buckle tongues to be sure they are secure.
5. Place chest clip at arm pit level. Insert chest clip tab and press
together. Pull outward on chest clip's ends to be sure it is secure.
6. Pull on harness adjuster to tighten harness straps. A snug strap
should not allow any slack. It lies in a relatively straight line without
sagging. It does not press on to the child's skin or push the child's
body into an unnatural position.
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
See section 5.25
22