Low Birthweight Harness Routing - Baby Trend Cover Me CV89 Owner's Manual

5.0 Installation and Use
5.25.2 Belt Shortening Clip Continued
3. Insert the sewn Anchor stamping
and the woven positioner stamping
through the inner most slot, slot #1
(Fig. 69a) - (Fig. 69b).
4. View from underside. Pull slack as
needed (Fig. 69c).
5. Thread the sewn anchor stamping
from the bottom of shell thru the
middle slot for storage. This storage
is so that the sewn anchor will not
interfere with function or cause a
mis-latch with shell and base when the
"low birth weight" positioner stamping
is used (Fig. 69d).
69
Internal Harness Mode
Seat Cut-Away
Buckle
Anchor Bracket
Belt Shortening Clip
Fig. 69a
Fig. 69b
Fig. 69c
Fig. 69d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use

5.26 Low Birthweight Harness Routing

1. Remove the head pillow (b) and store
for future use. (Fig. 70a).
2. Remove the harness loop ends from
the splitter plate and pull harness
through the seat back.
3. Remove harness cover, chest clip and
buckle tongue on child's left side and
set aside. Remove the cup holders and
set aside (Fig. 70b).
4. Pull harness webbing through the
body insert. Remove the body insert
and set aside.
5. Completely remove harness by pulling
up on child's right side of webbing and
set a side.
6. Lift seat fabric from the top and pull
crotch buckle through while removing
the seat fabric. Do not remove headrest
fabric (Fig. 70c).
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig. 70a
Fig. 70b
Fig. 70c
70