Overview; Usage Method - Epson S5U1C17564T2 Manual

1.

Overview

The S5U1C17564T2 (S5U1C17564T2: Software Evaluation Tool for S1C17564) is a board used to support the
development and evaluation of the Seiko Epson S1C17564 single-chip microcontroller.
The S5U1C17564T2 features through-holes for attaching expansion connectors to provide I/O pins for the
S1C17564, and can be used to expand functions by connecting a user board or similar via these connector
through-holes.
The S5U1C17564T2 can be used for developing S1C17564 software by connecting to the Seiko Epson
S5U1C17001H (ICDmini) emulator.
This product includes an IC socket, enabling it to be used with the Seiko Epson S1C17554 single-chip
micro-controller in addition to the S1C17564 included.
1.1

Usage Method

The S1C17564 software development environment can be set up using the procedure described below.
(1) Insert the S1C17564
(2) Connect the S5U1C17001H (ICDmini) to J5 and J6 on the S5U1C17564T2 via the dedicated cable
provided with the ICDmini.
(3) Provide power via the power supply connectors (J7, J8, J9).
(4) Connect the ICDmini to the PC
*1: The S1C17554 can also be mounted.
*2: Insert so that the triangular mark printed on the board aligns with pin 1 on the S1C17564. There is a risk
of damaging the S1C17564 if power is turned on while inserted incorrectly.
*3: For more information on connecting this device, refer to the S5U1C17001H User Manual (ICDmini
Ver2.0). Note that this device should be used with S5U1C17001H2 (ICDmini Ver 2.0) or later. It cannot
be connected to the S5U1C17002H (ICD Board).
*4: Never apply a voltage exceeding the power supply voltage input range for the S1C17564. For more
information on the S1C17564 power supply voltage input range, refer to the S1C17564 Technical Manual.
There is no need to supply power via J8 if the S1C17564 internal regulator is used. For more information,
refer to Section 3.
*5: The PC used for S1C17564 development must be installed with the GNU17 (S5U1C17001C) software
development tool. Note that this device should be used with GNU17 Ver 2.0.0 or later.
Note: When using the S5U1C17564T2, the spacers provided should be used to prevent shorting of the
mounted components.
S5U1C17564T2 Manual
(Rev. 1.0)
*1
into the IC socket (U1).
*3
*5
via the USB cable provided with the ICDmini.
Seiko Epson Corporation
*2
(It is already inserted at the time of shipping.)
*4
1. Overview
1