Table of Contents
Advertisement
4. Instalation (cont.)
Painting Care - Installations in Machines Surroundings:
Carrier recommends that, during installation in the machine surroundings, as a precaution to avoid damage to the paint, the machine
should be isolated/protected so that chips derived from cutting procedures on metal parts do not come in contact with the machine.
This precaution is necessary, since an incandescent chip can be stuck on the paint, giving the impression that the painting process has
a corrosion problem, when in fact it involves the impregnation of dirt from such installations in the surroundings.
It is also recommended that after the installation in the machine surroundings, the machine is cleaned thoroughly, so that possible
installation chips or dirt are not impregnated on the machine paint.
4.3. Dimensions
Units 30EV / 30EX
862 mm
Units in mm
16
ATTENTION
842 mm
Cables
entry/inlet
Water inlet
Water outlet
166 mm
217 mm
992
Cables
entry/inlet
Cables
entry/inlet
990
Advertisement
Table of Contents
