Changing The Network Connection To Ethernet From The Control Panel; Changing The Wi-Fi Direct (Simple Ap) Settings - Epson ET-M3180 Series User Manual

User's Guide
Network Settings
Select Set up Printer connection again (for new network router or changing USB to network, etc.) on the Install
Software screen, and then click Next.
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
2. Select General Settings > Network Settings > Wired LAN Setup.
3. Tap Start Setup.
4. Check the message, and then close the screen.
The screen automatically closes after a specific length of time.
5. Connect the printer to a router using an Ethernet cable.

Changing the Wi-Fi Direct (Simple AP) Settings

When Wi-Fi Direct (simple AP) connection is enabled, you can change the settings from > Wi-Fi
Direct > Start Setup > Change, and then the following menu items are displayed.
47