SolidRF Signal Plus Manual page 20

To uphold network protection standards and ensure compliance, all active cellular devices must
maintain a separation distance of at least six feet between the inside unit antenna and outside unit
antenna and at least four feet of separation distance from the inside unit. Use only the power supply
provided in this package. Use of a non-SolidRF product or accessory may result in damage to the
equipment or components of the equipment. The inside unit is designed for use in an indoor,
temperature-controlled environment (less than 100 degrees Fahrenheit). It is not intended for use in
attics or similar locations where temperatures may be in excess of that range.
RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all
persons.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modifications not expressly
approved by SolidRF could void the authority to operate this equipment.
FOR MORE INFORMATION ON REGISTERING YOUR SIGNAL BOOSTER WITH YOUR WIRELESS PROVIDER,
PLEASE SEE BELOW:
Sprint
T-Mobile/MetroPCS:
Verizon Wireless:
AT&T:
U.S. Cellular:
If you have any questions or concerns when installing or operating your cell phone booster, please
email us at
US: Support@SolidRFINC.com
Support@SolidRF.ca
Canada:
Or call our customer service number
Office (435) 319-6858
(877) 579-7878
Toll Free
https://www.t-mobile.com/support/coverage/register-a-signal-booster
https://www.t-mobile.com/support/coverage/register-a-signal-booster
https://www.verizon.com/solutions-and-services/accessories/register-signal-booster/
https://securec45.securewebsession.com/attsignalbooster.com/
https://www.uscellular.com/support/fcc-booster-registration
Safety Guidelines
20