Replacing The Solar Panel (Solar Hybrid) - Husqvarna Automower Solar Hybrid Technical Manual

7. Heat the new hexagonal hub using a hot air gun or
similar to enlarge the diameter of the hole. The
temperature of the hexagonal hub should be
150-200 ºC (300-400 ºF).
8. Carefully install the heated hub on the wheel
motor shaft. Press the hub all the way down until it
rests against the threads, this is to maintain
complete functionality of the labyrinth seal.
9. Allow the hexagonal hub to cool.
10. Install wheel motor, wheel, hub cap and ESD plug.
The wheel torque should be 10-12 Nm.
11. In some cases the ESD plug may be hard to
remove without damaging it. Damaged plugs must
be replaced.
5.21 Replacing the solar panel
(Solar Hybrid)
1. Fold the solar panel up
2. Switch off the machine using the main switch
3. Disconnect the cable which runs from the keypad
cover
4. Undo the two screws, which hold the large
connector, from the solar panel, two turns is
sufficient
5. Disconnect the connector
6. Remove the clip that holds the gas spring in the
solar panel
7. Unscrew the four screws holding the panel to the
hinge.
8. When reinstalling, ensure that the connector's
catch engages properly, and remember that the
new solar panel is extremely sensitive to knocks
5. REPAIR INSTRUCTIONS
English - 99